So, in order for the global routing table to have EIGRP routes in it, EIGRP has to first be enabled, then go through a process through with it determines which routes are Feasible successors (Best routes) and only then install them to the global routing table.
EIGRP has five basic messages it uses for this EIGRP collaboration between its neighbors.
EIGRP is a distance-vector protocol, meaning it uses variables in a path to determine the cost of getting to various networks. K-values represent the variables:
With basic EIGRP configurations there shouldn’t be any issues with EIGRP configured routers to able to create neighborships between each other. At this point I’m not 100% sure why this is an option but it is.
Below is an example of how to configure it. (I created a new sub-interface Gi0/0.70 on R1 and Fa0/1.70 on R3 for this example, just to not mess with the the current setup I have on sub-interface 60).
*** Super important, the static neighbor configuration needs to be configured on both routers ***
When EIGRP is up and operational, unicast and multicast EIGRP packets or constantly flooding the network to make sure EIGRP routes are up and are using the best path. These packets are important but not always necessary. There are situations when disabling an interfaces ability to spam the network with EIGRP packets is appropriate and will still allow for a fully operational EIGRP convergence. The way to achieve this is by configuring an interface to passive mode. EIGRP will still advertise the network/subnet configured on that interface, however, the interface will not participate in sending or processing of EIGPR packets.
Here is an example:
EIGRP works perfectly fine with its stock settings. However, there comes a time when settings need to get tweaked for various reason. EIGRP by default sends Hello packets every 5 seconds and has a Hold timer of 15 seconds. This means, by default, a router will send a hello packet every 5 seconds, and wait 15 seconds to receive a hello packet from its neighbors before it drops that route.
Hello packet set by each neighbor every 5 seconds:
EIGRP is a Cisco proprietary protocol. If you don’t mind being locked in using a vendor specific protocol you will then enjoy using a robust, well-developed protocol that will meet most enterprise network needs. Here are a few basic bullet points about EIGPR:
Configuring a basic EIGRP network:
Network Design (I’m using sub-interfaces on my equipment, as I have other traffic on other sub-interfaces):
Step 1) Enable EIGRP on every router: